Digital Trolling Motor Wiring Instructions

1. Determine TNT main control box mounting location. Mount control box and numbered terminal strip. Be sure to mount the control box with the wires facing down toward the deck. Keep in mind the two wire harnesses running from the main control box, one to the foot control and one to the terminal strip, are both 25' in length.

2. Route the trolling motor wires to the terminal strip.

3. Connect the port trolling motor to the terminal strip,
• blue #1 to white #1,
• green #2 to blue #2,
• red wire #3 to red #3,
• black #4 to black #4,
• white #5 to red #5.

4. Connect the starboard trolling motor to the terminal strip,
• white #5 to red #6,
• black #4 to black #7,
• red #3 to brown #8,
• green #2 to green #9,
• blue #1 to black #10.

5. With the control box off, connect 24 volts to the pigtails located on the terminal strip using #6 AWG marine grade battery cable. The 60-amp fuse for the system has been installed to protect the main control box at the factory. It is strongly advised to install an inline 60-amp fuse or breaker on the positive wire at the battery to protect battery cables.